WANT TO START SEEING SAVINGS TODAY?
You won’t believe the operational lifetime savings until you see it first hand. We can show you, in the material handling world, that our technology will improve your bottom-line.
cost Determine the total cost of the charger. Most forklift battery chargers sold do not have a cable that connects the charger to the power source. The cost of these cables and the cost of connecting the charger by an electrician should be considered. electricity supply Check the power supply. It should have the ability to handle normal operating amperage and start amperage. When the forklift battery charger is initially activated during the charging cycle, it consumes a lot of current. If there is insufficient electrical service, it may affect other electrical products in your facility. Output cable Pay attention to the output cable. The output cable that connects the charger to the truck is usually supplied with the truck battery charger. However, during battery charging, they may not be sufficient to fit the position of the charger (relative to the position of the forklift). It is important to place the charger and its output cable on the ground to prevent damage to the trRead More
fast charging If you implement a multi-shift system, you may benefit from another charging method called fast charging. Fast charging has great potential because it allows the lead-acid battery to charge for half the time of conventional charging (minimum 2-4 hours), which increases productivity and lowers the cost of purchasing additional batteries. Fast charging uses a higher current and does not slow down the charging speed like a conventional charger. This method of charging is actually safer than conventional charging methods because voltage and electrolyte levels are constantly monitored during charging. Fast charging is a weekly balanced battery to reduce sulfate, which takes 6 to 8 hours and may not be ideal for 24/7 operation. Opportunity charging The third charging method is opportunity charging, which sounds like: it can be charged as long as it is convenient. The opportunity to quickly charge to 80% of the battery and increase the current, then charge to 100%, exteRead More
To sum up, as for Lead-acid battery, we recommend the low-frequency charger, as known as a 50-60hz charger or power frequency charger, Which has the below advantages: stable and high reliable easy repair and Maintainance easy to operate And for the LIthium battery, we recommend the high frequency, and the efficiency can reach 95%, which has the below advantages: maximum energy saving the longer life span of your battery reduced heat generation in the battery lower water consumption low weight and limited heightRead More